Bmw E60 E61 BT Module Location & How To Activate Bluetooth On IdriveClick Here to buy The Forte Gearbox Treatment
You said no audio and no voice control. iDrive controller is controlled by the CCC not the other way around. The CCC just uses the controller as an input device. It could never prevent audio from working. You can disconnect the controller and still get audio. It's also possible the TCU failed.
Pull the light bulbs and sockets (red arrow) straight out of the trim panel. Figure 17 Using a flathead screwdriver, remove the rear vent retaining clips (red arrows) from the vent. Figure 18 Slide the vent straight out of the center console. Then flip the vent over to disconnect the electrical connector (red arrow).
The BMW CCC (Car Communication Computer) is a 2nd generation head unit and a real-time operating system that has an 8.8” display, a DVD drive for DVD based maps, a CD drive and an AUX input. It debuted on the market in 2003 with E60/E61 5 Series BMW, and since then has featured in the following models: 1-Series E81/E82/E87/E88. Looking at age of your car the problem is most likely a problem with the little micro button switches in your key. If you have the second key . the one that hasn't been used so much, try using that for a while and i'll bet you don't get the fault message.

49 posts · Joined 2017. Add to quote. Only show this user. #28 ·Mar 26, 2023. If everything is working on radio and just no screen output then its pretty much the video card, however fixing it cost as much as getting a new ccc of ebay…for the android screen they are pretty much reliable, so far i have no problem in mine and love it.

Interestingly it is a known problem with seals on the E60. The seals are renowned for leting water into the boot and the water tends to accumulate in the boot around the controller unit for the Idrive which is near the battery.
Hi, yesterday I did the ambient light in my car but I did not finished, so to be sure that battery will be okay i disconnected the battery for like 24 hours. Today I finished with everything and i found out that my idrive controller is not working. I checked the fuse 29 was fine, but to be sure i replaced him. It is BMW F10 2010.
iTrader: ( 0) Idrive controller upgrade to touch version. As part of my on-going car upgrades (this part being an upgrade of nav (sa6un) to “Nav plus” (SA6UP). I started the project by switching the 6.5” touch screen to the 8.8” version and was delighted with the result. I have posted instruction for fitting and coding in a couple of
dS41.
  • df4p0934gs.pages.dev/34
  • df4p0934gs.pages.dev/314
  • df4p0934gs.pages.dev/281
  • df4p0934gs.pages.dev/339
  • df4p0934gs.pages.dev/40
  • df4p0934gs.pages.dev/329
  • df4p0934gs.pages.dev/357
  • df4p0934gs.pages.dev/410

    • bmw e60 idrive controller not working