AMSOIL 0W-30 MS 100% Synthetic European Motor Oil. Product Code: EOTQT-EA. Designed for the unique demands of gasoline, diesel and hybrid European vehicles. European formula features precise blend of synthetic base oils and premium additives. Exceptional engine protection without harming emissions systems.

Step 4 – Replace oil filter. The oil filter is located directly above the drain plug. Use your oil filter wrench, and wrap it around the oil filter. Turn it counter-clockwise to remove it. Before installing the new one in place, rub some oil on its rubber gasket to prevent it from tearing or prematurely leaking.
Q7 MK 1 Discussion - 4.2 oil change tips - Cartridge-type oil filter is accessed by unscrewing a plastic housing at the rear top of engine (under a decorative cover). You need an pretty big adjustable wrench to remove the housing, or use a 32 mm socket, which works best.

Understood. The oil filter housing is part of the drivers side engine support. The diagram below shows its location. After that is removed, you can just remove the drain plug on the oil pan to drain the oil and then re-install the plug and then add the oil.

Received 19 Likes on 15 Posts. Looking for advice/thoughts re: oil leaking f/ 2019 Q7. My Q7 was purchased as a CPO with under 6k miles, and it's now sitting at 25.5k miles, on the ODO. It's had three oil changes, all done at the dealership under Audicare. The last oil change was on 7/31/2020 with 23.5k miles on the ODO. 9. Drain the oil. Place the oil catch pan under each drain plug and remove the five drain plugs to drain the oil. You have to remove the engine noise insulation sound guard 2 to access plug 5. I am considering drilling an access hole in sound guard 2 so I won’t have remove sound guard 2 again. a. Plug 1 is 5mm hex. b. Plug 2 is 8mm hex. 5. Fill it up. Go 1/2 qt short and then measure via the stick to fill the last amount. 6. check for leaks around drain plug, belly pans back on. This instruction for oil filter removal is NOT for Q7 with 3.6l engine. It is for 4.2l engine. The 3.6l engine oil filter change is not hard but it is quite messy. How To Step 4. Locate the 8mm hex bit transfer case fluid drain plug on the bottom center area of the transfer case. Loosen, and remove the Audi Q7 transfer case fluid drain plug and allow the old dirty transfer case fluid to thoroughly drain into a waste oil drain pan container. (Image 4 & 5) The average price of a 2019 Audi Q7 oil change can vary depending on location. Consult your owner’s manual for oil type, oil amount, oil pan location, drain plug and oil filter sizes and KR474.
  • df4p0934gs.pages.dev/151
  • df4p0934gs.pages.dev/445
  • df4p0934gs.pages.dev/80
  • df4p0934gs.pages.dev/182
  • df4p0934gs.pages.dev/242
  • df4p0934gs.pages.dev/103
  • df4p0934gs.pages.dev/355
  • df4p0934gs.pages.dev/203

    • audi q7 oil drain plug location